Future-automation PLH Bedienungsanleitung

ISSUE: 006www.futureautomation.co.ukFUTUREAUTOMATIONPLH Plasma Lift Hinge MechanismInstruction Sheet

Carefully hook the screen with the uprights properly secured back onto the mounting frame and position. Stage 8Fixing the screen to the liftSimply mo

Stage 9Run The MechanismRUNNING THEMECHANISMIt is very important that oncethe mechanism is set up, thelift is run up and down anumber of times and tha

INPRESSStage 10PLH mechanisms are all factory set to rotate 45REMOTECONTROLS IN Takes the screen inside the cabinet.OUT Takes the screen out of the

Rotates90To store a position in the memoryMechanism can be controlled through the IR or Contact closure ( see sheet 14)Instruction SheetPLH Plasma L

The PLH mechanism must be connected to the AC1, AC2, DC1 and DC2 blocks of connections. Connect the IEC Power Lead HereARemove this screw to release

18pinsThere are a number of LEDs which will light up when thecorresponding contact closure connections are shorted together.A red LED will light up wh

91234567816pinsPIN 1: INPIN 6: OUTPIN 3&4: GROUNDPIN 2: INPIN 3: OUTPIN 5: GROUNDSheet 15 of 17ISSUE: 006www.futureautomation.co.ukFUTUREAU

AC1Gives an ouput of 240V(or 110V) to control the Plasma Lift motor.Outputs stay live for 60 seconds afterthe OUT or IN functions are selected.DC1A lo

M6 x 25mmPointed x 8The fixings immediately below are the standard PL fixings supplied with every PL product. There will be one other pack of fi

Your Pack Should Contain1 PLH -Plasma Lift HingeMechanismSuitable for 26" to 50"screens1 Standard PLFixtures PackThe contents of which can b

Stage 1Check The Operation Of The MechanismOUT: Reveal Screen IN: Hide ScreenSTOP: Stops Mechanism See SHEET 11 for further controlsCon

AluminumFlap6mm Flap12510780ADETAIL A SCALE 1 : 5Remove mount and place base central onto the beam into position and reattach the mount.Fix the base

BDETAIL B SCALE 2 : 3Stage 3Fixing The Lift In The CabinetPlace the mechanism within the cabinet. Raise the beam to the top and guide the base carefu

CDETAIL C SCALE 1 : 1By adjusting the screw up and down, you can adjust the stop height of the beam, and also the base panel.Stage 4Adjusting Base Pan

CDETAIL C SCALE 1 : 3Stage 5Positioning The Base PanelThere should be a gap of about 3mm around the edges of the base panel to the cabinet. See Stage

123Adjusting The Flap-Up PositionStage 61By adjusting the white screw,at each side of the lift, you canadjust the tilt of the flap.By winding the push

DDETAIL D SCALE 1 : 4By adjusting the bolts under each flap arm as circled, it is possible to alter the angle the flap opens to. It isvery important t